temperature reduction
英 [ˈtemprətʃə(r) rɪˈdʌkʃn]
美 [ˈtemprətʃər rɪˈdʌkʃn]
网络 温度还原
英英释义
noun
双语例句
- For the non-isothermal crystallization, the crystallization rate was increased while speeding up the temperature reduction; according to Avrami equation and Ozawa equation, the ratio of Avrami index and Ozawa index was calculated as 1.31-1.49, the activation energy-87.96 kJ/ mol.
在非等温结晶过程中，结晶速率随降温速率的增大而提高，综合利用Avrami方程和Ozawa方程得到Avrami指数与Ozawa指数的比值为1.31～1.49，非等温结晶活化能为-87.96kJ/mol。 - Influence of Hydrogen in Gas on Low Temperature Reduction Pulverization of Charge
氢气对高炉炉料低温还原粉化的影响 - Ensure the temperature reduction fans on the rear of the ultrasonic cabinet as well as on the both ends of the transducer work properly.
超音波箱体后端降温风扇应正常运转，振动子两端风扇应正常运转。 - According to the principle, this article examines relative process used in gas gathering station using initial pressure energy of natural gas for throttling temperature reduction and gives a calculation method of injection volume of methanol to inhibit formation of hydrate during throttling temperature reduction.
本文运用这一原理，研究利用天然气原始压力能，实现节流降温在集气站所采用的工艺流程，给出了在节流降温过程中，不形成水化物所需的甲醇注入量的计算方法。 - The results showed that the temperature reduction coating had high emissivity, high reflectivity and make the temperature dropped 4~ 8 degree; the phase change coating had both function of good temperature self-adaptive and better thermal camouflage and IR fusion effect with the background.
结果表明，降温涂层具有高发射率、高反射率和4~8℃的降温效果；相变涂层具有优良的温度自适应功能，并在短时间内可实现对热源的伪装效果及与背景的融合性。 - This paper expounds the internal connection and regularity among sintering technological conditions, microscopic structures of sinter and degradation during low temperature reduction.
本文阐明了烧结工艺条件、烧结矿微观组织结构与烧结矿低温还原粉化的内在联系和规律。 - Comparison with the common exterior wall green coating, market-available green coating and military green coating, a temperature reduction performance of home-made green solar heat reflective coating were studied.
与普通外墙用绿色涂料、市售绿色涂料和军用绿色涂料进行比较，研究了自制的绿色太阳热反射涂料的降温性能。 - Because of high temperature reduction is the traditional synthesis method, and the characteristics of the materials were impacted by synthetic temperature, calcining time, the content of carbon additives, impurities.
因采用的是高温还原传统的合成方法，材料的特性受到合成温度，煅烧时间，碳添加剂的含量，杂质等因素的影响。 - Experimental results show that this method increases the temperature reduction in the hot side of the radiator.
通过对比试验的验证，散热器冷边加水提高了散热器的热边温降。 - Test on molybdenum powder without low temperature transition and high temperature reduction
无低温过渡高温还原钼粉试验研究